Mesoporous WO3-graphene photocatalyst for photocatalytic degradation of Methylene Blue dye under visible light illumination

Advanced oxidation technologies are a friendly environmental approach for the remediation of industrial wastewaters. Here, one pot synthesis of mesoporous WO_3 and WO_3-graphene oxide(GO) nanocomposites has been performed through the sol–gel method. Then, platinum(Pt) nanoparticles were deposited onto the WO_3 and WO_3-GO nanocomposite through photochemical reduction to produce mesoporous Pt/WO_3 and Pt/WO_3-GO nanocomposites. X-ray diffraction(XRD) findings exhibit a formation of monoclinic and triclinic WO_3 phases. Transmission Electron Microscope(TEM) images of Pt/WO_3-GO nanocomposites exhibited that WO_3 nanoparticles are obviously agglomerated and the particle sizes of Pt and WO_3 are ~ 10 nm and 20–50 nm, respectively. The mesoporous Pt/WO_3 and Pt/WO_3-GO nanocomposites were assessed for photocatalytic degradation of Methylene Blue(MB) as a probe molecule under visible light illumination.The findings showed that mesoporous Pt/WO_3, WO_3-GO and Pt/WO_3-GO nanocomposites exhibited much higher photocatalytic efficiencies than the pure WO_3. The photodegradation rates by mesoporous Pt/WO_3-GO nanocomposites are 3, 2 and 1.15 times greater than those by mesoporous WO_3, WO_3-GO, and Pt/WO_3, respectively. The key factors of the enhanced photocatalytic performance of Pt/WO_3-GO nanocomposites could be explained by the highly freedom electron transfer through the synergetic effect between WO_3 and GO sheets, in addition to the Pt nanoparticles that act as active sites for O2 reduction, which suppresses the electron hole pair recombination in the Pt/WO_3-GO nanocomposites.     

碳量子点掺杂氮化碳提高的光电化学阴极保护性能研究

目的研究g-C_3N_4/C-Dots-M复合材料的光电化学阴极保护性能。方法采用X射线衍射(XRD)、扫描电子显微镜(SEM)和紫外可见漫反射光谱技术对样品的晶体结构、微观形貌和光吸收性能进行表征。通过电化学测试可见光照射下g-C_3N_4/C-Dots-M复合材料光电极偶联316L不锈钢后的光电化学阴极保护电流密度和电位变化曲线,研究材料的光电化学阴极保护性能。结果可见光照射下,该偶联体系的光致混合电位下降至-0.43 V(vs. Ag/AgCl),光电化学阴极保护电流密度达到4.3μA/cm。结论得益于碳量子点优异的电子传导特性,g-C_3N_4/C-Dots-550复合材料的光电化学阴极保护性能比纯g-C_3N_4的明显增强。该复合材料在光电化学阴极保护方面展现了较大的应用潜力。     

DZ125合金HY3包覆型涂层退除研究

目的 研究化学法退除DZ125合金HY3包覆型涂层。方法 采用真空电弧镀技术（AIP）在定向凝固镍基高温合金DZ125上制备包覆型涂层HY3,利用化学方法完全退除基体上的涂层,通过失重法研究对比1#和2#退除溶液退除HY3涂层和DZ125合金的退除速率,采用扫描电镜（SEM）对退除后的HY3涂层和DZ125基体的微观组织进行观察。结果 经过100 min,2#溶液可以将20 ?m左右的HY3涂层完全退除,采用1#溶液需要超过100 min才能完全退除涂层。两种对DZ125合金的腐蚀性很小,对于同一种合金而言,1#溶液和2#溶液对合金的腐蚀速率比值为1︰13。在1#溶液中,合金与涂层腐蚀速率的比值为1︰87.65;在2#退除溶液中,合金与涂层腐蚀速率的比值为1︰6.81。结论 1#溶液更加适合退除DZ125合金上的HY3涂层。     

强酸型离子交换纤维富集-火焰原子吸收测定水中痕量铜、铅、镉、镍

通过强酸型离子交换纤维柱,在同一水样中同时富集和洗脱了铜、铅、镉、镍,采用火焰原子吸收光谱法测定,并对富集条件及洗脱条件、干扰因素进行了探讨。该方法简便易行,回收率在96.1%~105.5%之间,测定的相对标准偏差小于5.0%。     

工作场所空气中硫酸雾（SO3）的分析

采用碘量法测定工作场所空气中的三氧化硫及硫酸雾，三氧化硫及硫酸雾经中性水吸收后与碘化钾和碘酸钾反应，析出的碘与淀粉指示剂作用产生蓝色，进行比色测定。     

高压微波络合消解石墨炉原子吸收分光光度法测定环境空气中锡

用有机滤膜采集空气中颗粒物样品，用HNO3-HCl-HClO4-EDTA微波络合消解后制成样品溶液。用石墨炉原子吸收分光光度法可确定样品溶液中锡的浓度。该方法具有消解完全，无损失，灵敏度高，准确度、精密度好等特点。     

HPLC法测定饲料中维生素A、维生素D 3 和维生素E

建立了以w(C2H5OH)=95 %乙醇直接提取,高效液相色谱仪在波长280 nm和254 nm处连续测定饲料中维生素A、维生素D3和维生素E的方法.色谱柱为大连依利特Hypersil ODS C18(25 cm×4.6 mm×5 μm),流动相为甲醇-水,流速为1.2 mL/min.维生素A、维生素D3、维生素E的质量浓度分别在1.0 mg/L～20.0 mg/L、0.5 mg/L～15.0 mg/L 、2.5 mg/L～50.0 mg/L范围内与峰面积呈良好的线性关系,检测限分别为0.3×10-6 μg、0.04×10-6 μg、5.0×10-6 μg,相对标准偏差分别为1.6 %、2.7 %、2.4 %,平均回收率分别为99 %、102 %、98 %.     

三维虚拟地理环境构建与应用

可量测三维虚拟地理环境是数字地球应用的基础平台。本文研究了三维虚拟地理环境构建空间几何建模与纹理建模关键技术。提出了一种适用于大规模生产建库的可量测三维虚拟地理环境构建的生产工艺模型和三维虚拟模型数据获取的方法。介绍了三维虚拟地理环境在城市规划、房产经营管理等方面的应用。     

分光光度法测定雨水中微量过氧化氢的研究

本文提出了以钛（ＩＶ） 过氧化氢 ２ （３，５ 二溴 ２ 吡啶偶氮） ５ 二乙氨基苯酚（３，５ ｄｉＢｒ ＰＡＤＡＰ）三元配合物体系光度测定雨水中微量过氧化氢的方法，该方法简便，灵敏度和选择性较高，所得结果令人满意     

Mechanics Principle and Engineering Application of Split Layer and Bed Separation of Mining Overburden

<正>To control land surface subsidence caused the underground mineral exploitation and the catastrophic phenomena such as serious damage of buildings, waterbodies, cultivated lands, railways, bridges caused by land subsidence, bed separation grouting technology of overburden is put forward. To provide theoretical support for the technology, the characteristics and the mechanics mechanism of mining overburden from layer-split to formation of bed separation are studied. On the basis of elastic sheet board theory, calculation formula of rock sheet deflection is presented, and the mechanics criteria of the separation formation and the calculation formula of bed separation volume are set up. Finally, the applications and technics of bed separation grout technology of mining overburden to control land subsidence in china are introduced.